Introducing Loombands
Hello Readers,
*•.¸♡ Happy Guru Purnima ♡¸.•* Anyways, Today I will show you how to make loombands. You will need
clips. They are usually called C clips. But the C clips look like an
(au), So that's why I call them au clips. You will also need a packet of loom bands. In this post, I will teach you how to make A single loom bracelet. I will show you how a unique loom band bracelet comes out and how a fish tale loom band bracelet comes out. The fishtail loom band bracelet takes a longer time to do but turns out beautifully.
π Single Lom Bracelet π Fish Tail Loom Bracelet


What you will need
- color packets of looms (put them in order on which one you want to go first)

- 1 au clip
I want my order to go as purple, yellow, orange. You don't have to put the same colors as me.
1st Step: Take your 1st loomband and twist it on both of your fingers, as shown below.

2nd Step: Add your next loomband on top of the one you twisted.

3rd Step: Take the purple one and place both sides of it on the top. If this step is confusing, look at the picture to help you understand.

4th Step: Put the other side up like in the 3rd step.

5th step: Repeat steps 1-4 until you think you have done enough.
6th step: One you think you have finished, you should end up as the picture shown below.

7th Step: Take the other side and put it on one finger.

8th Step: Take your other 2 fingers and squeeze it in there.

9 steps: Then attach the au clip.

10 step: Then, take your fingers out of it.

11th step: Then hold the other end.
12th Step: Attach the au clip to the other end.

Ta-Da!! Here you go, it's a necklace!!
Comments
Post a Comment